Cutlass Bearings 1996 20 Open Gas
#1
I need to replace both cutlass bearings and was wondering the process and what the cost might be. thanks
Reply
#2
I never had it done but I watched yard workers press them out without pulling the shafts, just the props. They had a hydraulic press that clamped on the shaft.
 It did not look like a DIY job. No idea of the cost but they were done in no time.  Just my 2 cents.  Capt.  George
Reply
#3
Thanks Capt., Was about to go in the water and noticed the rubber part of the bearing coming out of the stut in the rear by the prop. Figured it was time to get it done, probably due. Thanks again.
Reply
#4
(06-03-2016, 06:08 PM)roboh20 Wrote: I need to replace both cutlass bearings and was wondering the process and what the cost might be. thanks

Just had them replaced , bearings engine alinement shaft seals $ 1100 norms props works dock side work great workman ship. 941 830 2380 fl west cost
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Unknown noise from Tiara 3800 Open engine room Tony Saitta 4 633 11-16-2026, 01:54 PM
Last Post: liambrown
  [Tiara Open] 36' Open interior lights Rick B 0 119 11-14-2026, 12:22 PM
Last Post: Rick B
  38 open bathroom recessed light bulb twilson0929 3 725 08-26-2026, 06:22 AM
Last Post: twilson0929
  Replacement of Carbon Filter on vent line from Holding Tank. 38 Open ReelMagic 1 559 08-18-2026, 02:11 PM
Last Post: hiccup
  2001 38’ Open interior table base removal twilson0929 3 1,000 07-07-2026, 08:13 AM
Last Post: hiccup



Users browsing this thread: 1 Guest(s)
Advertisements

>