Posts: 43
Threads: 16
Joined: Nov 2011
Reputation:
0
Home Port: Red Bank, New Jersey
Vessel Info: 1996 Tiara 29 open, Twin Crusaders 454XLI
I need to replace both cutlass bearings and was wondering the process and what the cost might be. thanks
Posts: 494
Threads: 22
Joined: Apr 2012
Reputation:
5
Home Port: Stuart, FL
Vessel Info: 1988 36' Convertible with new 8.1 Crusaders.
Exceptional condition, inside, outside, bilges and engines.
I never had it done but I watched yard workers press them out without pulling the shafts, just the props. They had a hydraulic press that clamped on the shaft.
It did not look like a DIY job. No idea of the cost but they were done in no time. Just my 2 cents. Capt. George
Posts: 43
Threads: 16
Joined: Nov 2011
Reputation:
0
Home Port: Red Bank, New Jersey
Vessel Info: 1996 Tiara 29 open, Twin Crusaders 454XLI
Thanks Capt., Was about to go in the water and noticed the rubber part of the bearing coming out of the stut in the rear by the prop. Figured it was time to get it done, probably due. Thanks again.