38 open 2001 Clamp-on rod holders
#1
Hi gang,

What is the diameter of the grab rail on the stern of a 2001 38 open & the grab rails on the side of the Tiara radar arch? I would like to install a couple of clamp on rod holders.

Thanks, Andy
Reply
#2
My guess is @ 1”


Sent from my iPhone using Tapatalk
Reply
#3
I believe they are 7/8 or 1" I went through a couple of pairs and ended up with cisco rod holders out of ohio. The tube holders can be rotated 360* and tilt up and down. I mounted two on port and 2 starboard on rail mounts for planer board rods for salmon. Could not be happier. I will try to find my receipt to verify the diameter I think they custom made the clamps to my diameter. The off the shelf taco marine holders were either under or over the diameter I needed.

I will be back on the boat friday and will take a pic of my set up.

Sent from my SM-N970U using Tapatalk
Reply
#4
Thanks so much
Reply
#5
Cisco tube holders rotate 360* and tilt up and down with no tools.[Image: f5de84790e133d2c6e656c72827b8d2a.jpg][Image: 5e6758ff65656854b20e849bd3bb1907.jpg][Image: 5d1e06200ac9fa7bfaf0347c74c251b1.jpg]

Sent from my SM-N970U using Tapatalk
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Unknown noise from Tiara 3800 Open engine room Tony Saitta 4 636 11-16-2026, 01:54 PM
Last Post: liambrown
  [Tiara Open] 36' Open interior lights Rick B 0 120 11-14-2026, 12:22 PM
Last Post: Rick B
  38 open bathroom recessed light bulb twilson0929 3 726 08-26-2026, 06:22 AM
Last Post: twilson0929
  Replacement of Carbon Filter on vent line from Holding Tank. 38 Open ReelMagic 1 559 08-18-2026, 02:11 PM
Last Post: hiccup
  2001 38’ Open interior table base removal twilson0929 3 1,001 07-07-2026, 08:13 AM
Last Post: hiccup



Users browsing this thread: 1 Guest(s)
Advertisements

>